Network Technologies SM-nXm-15V-LCD - Manual (Page 40)

NTI VEEMUX VIDEO MATRIX SWITCH
36
5. Press < L> to load the firmware (hex) file. This will prepare the file for transfer to the VEEMUX.
If the file fails to load, press the < C> key to clear the old firmware, and press < L> to load it again.
6. When the message “ Start sending file via Xmodem protocol.. ” ' appears, the VEEMUX is waiting for the Firmware file to
be uploaded.
A box or some other characters may be displayed repeatedly on the line below this message while the VEEMUX waits;
this is normal.
7. Click “ Transfer” > “Send File ...” from the HyperTerminal menu bar
8. Select “ Xmodem” from the Protocol drop-down menu,
9. Click “ Browse” . Go to the directory containing the firmware to load into the VEEMUX. Select to highlight the hex file,
click “ Open” , then click “ Send” .
10. A window will appear displaying information about the upload operation, including the upload process. It may take a few
seconds for the upload to begin.
DO NOT DISRUPT POWER while the firmware is uploading to the VEEMUX.
11. When the upload is completed, the command prompt will return. Power the VEEMUX OFF, then ON again. Upgrading is
complete, and the VEEMUX is ready to use.