Ricoh LD435c - Manual (Page 109)

Edit
101
3
❖ Back Margin: Top/Bottom
Specify top and bottom margins on the back side of copies in Margin Adjust-
ment mode.
• Top
• Bottom
Default:
• Metric version: T / B: 0mm
• Inch version: T / B: 0.0"
❖ 1 Sided → 2 Sided Auto Margin: TtoT
In 1 sided to 2 sided Duplex mode, you can specify the margins on the back side.
The margin is set to the same value of "Back Margin: Left/Right".
• Left
• Right
Default:
• Metric version: Right 5 mm
• Inch version: Right 0.2"
❖ 1 Sided → 2 Sided Auto Margin: TtoB
In 1 sided to 2 sided Duplex mode, you can specify the margins on the back side.
The value set for "Back Margin: Top/Bottom" is used.
• Top
• Bottom
Default:
• Metric version: T / B: 0mm
• Inch version: T / B: 0.0"
❖ Erase Border Width
Top/Bottom 0mm
Default:
• Metric version: 10mm
• Inch version: 0.4"
❖ Erase Original Shadow in Combine
In Combine mode, you can specify whether to erase a 3 mm, 0.1" boundary
margin around all four edges of each original.
• On
• Off
❖ Erase Center Width
Specify the width of the erased center margins with this function.
Default:
• Metric version: 10 mm
• Inch version: 0.4"