Ricoh LD435c - Manual (Page 124)

Copier / Document Server Features
116
3
Input/Output
This section describes the user tools in the Input/Output menu under Copier /
Document Server Features.
Default settings are shown in bold type.
❖ Switch to Batch
You can select to have Batch mode or SADF mode displayed when you press
the [Special Original] key.
• Batch
• SADF
❖ SADF Auto Reset
In SADF mode, an original must be set within a specified time after the pre-
vious original has been fed.
You can adjust this time from 3 to 99 seconds in increments of 1 second.
The default setting is 5 second(s).
❖ Rotate Sort: Auto Paper Continue
Specify to continue copying when paper of the required orientation has run
out during rotate sort.
• On
Copying continues using copy paper of a different orientation. The copy
job will finish even if you have left the machine.
• Off
When paper of the required orientation runs out, the machine stops copy-
ing and prompts you to supply copy paper. After you have loaded paper,
the machine will continue copying.
❖ Memory Full Auto Scan Restart
When memory becomes full while scanning originals, the machine can make
copies of scanned originals first, and then automatically proceed scanning re-
maining originals.
• On
You can leave the machine unattended to make copies, but sorted pages
will not be sequential.
• Off
When memory becomes full, the machine stops operation allowing you to
remove the copy pages delivered on the output tray.
❖ Letterhead Setting
If you select [Yes] in this function, the machine rotates the image correctly.
• Yes
• No
Orientation-fixed (top to bottom) or two-sided paper might not be printed
correctly depending on how the originals and paper are placed.