Ieee 1394 (ipv4 over 1394) – Ricoh LD435c User Manual
Page 31
Network Settings
23
1
IEEE 1394 (IPv4 over 1394)
This section lists the settings required for sending e-mail with an IEEE 1394 con-
nection.
For details about how to specify the settings, see "Interface Settings" and "File
Transfer".
Note
❒ [IEEE 1394] is displayed when the IEEE 1394 interface board is installed.
❒ For the Effective Protocol setting, check that the protocol you want to use is
set to [Active].
❒ When POP before SMTP is set to [On], also make setting for Reception Proto-
col and POP3 / IMAP4 Settings.
❒ When setting POP before SMTP to [On], check POP3 port number in E-mail
Communication Port.
Reference
p.59 “Interface Settings”
p.69 “File Transfer”
Menu
User Tool
Setting Requirements
Interface Settings/IEEE 1394 IPv4 Address
Necessary
Interface Settings/IEEE 1394 DDNS Configuration
As required
Interface Settings/IEEE 1394 Host Name
As required
Interface Settings/IEEE 1394 Domain Name
As required
Interface Settings/IEEE 1394 WINS Configuration
As required
Interface Settings/IEEE 1394 IPv4 over 1394
Necessary
Interface Settings/Network
IPv4 Gateway Address
Necessary
Interface Settings/Network
DNS Configuration
As required
Interface Settings/Network
Effective Protocol
Necessary
File Transfer
SMTP Server
Necessary
File Transfer
SMTP Authentication
As required
File Transfer
POP before SMTP
As required
File Transfer
Reception Protocol
As required
File Transfer
POP3 / IMAP4 Settings
As required
File Transfer
Administrator's E-mail Address
As required
File Transfer
E-mail Communication Port
As required
File Transfer
Program / Change /
Delete E-mail Message
As required
File Transfer
Scanner Resend Interval Time
As required
File Transfer
Number of Scanner Resends
As required