Runco 3DIMENSION D-73D - Manual (Page 38)

Installation
22 D-73d Series Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the D-73d installation process. The sections following
this one provide detailed instructions.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 23
2 Choose and install a 3D-compatible screen 24
3 Install CineWide lens mounting assembly (stationary base
plate or AutoScope lens motor – optional) 31
4 Mount the projector 36
5 Mount the Primary DHD Controller, Secondary DHD
Controller and 3Dimension Processor 37
6 Connect the Primary and Secondary DHD Controllers to
the projector 38
7 Connect the 3Dimension Processor to the Primary and
Secondary DHD Controllers 40
8 Connect other external equipment to Primary DHD
Controller (optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (retractable screens
or screen masking)
• External IR repeater
• Network hub, router or gateway (Ethernet)
42
9 Connect signal sources to the 3Dimension Processor 46
10 Connect system components to AC power 50
11 Power up the system and perform optical alignment
procedures (refer to Table 3-6) 51
12 Display calibration —Primary DHD Controller: set
Adjustment Mode to Primary; adjust the following for each
input and display mode (resolution and frame rate); save
settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance 67
13 Display calibration —Secondary DHD Controller: set
Adjustment Mode to Secondary; repeat Step 12 67