3d processing, 3d mode, Pre l iminar y – Runco 3DIMENSION D-73D User Manual
Page 93
D-73d Series Installation/Operation Manual
77
PRE
L
IMINAR
Y
You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:
• Brightness
• Contrast
• Color saturation
• Tint
• Sharpness
• Gamma
• Lamp Settings
• Color temperature and white balance
To select a memory preset, press
or
to highlight it and press ENTER.
To save the settings for the current input and display mode to the Custom 1 or Custom 2
memory preset, select it, press
or
to highlight Save and press ENTER.
To reset the Custom 1 or Custom 2 memory preset to its factory-default state, select it,
press
or
to highlight Reset and press ENTER.
Select 3D Processing from the Main Menu to set the following options related to
formatting and delivery of HDMI 3D content.
3D Mode: Select 3D Mode from the 3D Processing menu to specify how the Primary and
Secondary DHD Controllers process the “left eye” and “right eye” image components
respectively.
• Choose Auto to have the D-73d determine the appropriate 3D mode based on the
HDMI vendor-specific InfoFrame data. This is the default setting.
• Choose Off for 2D content.
• Choose Side-by-Side to have the Primary
and Secondary DHD Controllers scale the
left and right image halves respectively to fill
the screen.
Side-by-Side multiplexing is used with 1080i
source material.
• Choose Top-and-Bottom to have the
Primary and Secondary DHD Controllers
scale the top and bottom image halves
respectively to fill the screen.
Top-and-Bottom multiplexing is used with
720p or 1080p source material.
To save the settings for the current input and display mode to the
ISF Night or ISF Day memory preset, select Save ISF Night or Save
ISF Day from the Calibration menu (refer to Save ISF Night/Save
ISF Day on page 83).
Note