Reverse eyes, Sleep timer, Information – Runco 3DIMENSION D-73D User Manual

Page 94: Signal / system, Network, Field service / manufacturing, Pre l iminar y

Advertising

Operation

D-73d Series Installation/Operation Manual

PRE

IMINAR

• Choose Frame Packing to have the 3Dimension Processor decode frame packed

data into left and right eye data. In this mode, the DHD Controllers do not perform any
3D processing.

Reverse Eyes: By default, the Primary and Secondary DHD Controllers are dedicated to
“left eye” and “right eye” image processing respectively. To reverse this relationship,
choose Reverse Eyes from the 3D Processing menu and set it to On.

Sleep Timer

Select Sleep Timer from the Main Menu to turn off the D-73d after a specified interval.
Press

to select Off, 30 Minutes, 60 Minutes, 90 Minutes, 2 Hours or 4 Hours.

Then, press ENTER.

Information

Signal / System: Select Information from the Main Menu, then choose either Signal or
System to display information about the current input signal (resolution, frequency, type et
cetera) and installed firmware versions, as well as other information that uniquely identifies
your DHD Controller and display device.

Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.

Network: Select Information from the Main Menu, then choose Network to display
information about the Ethernet network connection.

To enable network communication via Ethernet, refer to IP Configuration on page 88.

Field Service / Manufacturing: The Field Service and Manufacturing menus are
password-protected and intended for use only by Runco service personnel and factory
technicians.

Sleep Timer

Off

30 Minutes

60 Minutes

90 Minutes

2 Hours

4 Hours

➤