D-73d/cinewide with shasta anamorphic lens, Pre l iminar y – Runco 3DIMENSION D-73D User Manual
Page 51
D-73d Series Installation/Operation Manual
35
PRE
L
IMINAR
Y
D-73d/CineWide with Shasta Anamorphic Lens: Figure 3-10 shows the Shasta
anamorphic lens base plate assembly for a D-73d/CineWide.
Figure 3-10. D-73d/CineWide with Shasta Anamorphic Lens Base Plate -
Exploded View
To install the Shasta anamorphic lens base plate on a D-73d/CineWide:
1.
Place the projector upside down on a blanket or other soft, flat surface.
2.
Remove the two front feet from the projector.
3.
Place the two rectangular spacers on the bottom of the projector as shown.
4.
Place the CineWide base plate on top of the spacers.
5.
Secure the base plate to the projector with the four (4) supplied, M5 x 0.8 x 20mm
Phillips screws.
6.
Re-attach the front feet to the projector.
DO NOT OVER-TIGHTEN THE SCREWS.
Screw, Phillips
Pan-Head,
M5-0.8 x 20mm (4x)
2
1 CineWide
Base Plate
for Shasta
Lens
Rectangular
Spacer (2x)
3
Caution