Ricoh Type 480 - Manual (Page 107)

Settings
99
9
❖ ❖ ❖ ❖ Change Initial Mode
Select [Standard] to use the stand-
ard settings as the initial mode
which is the mode of the machine
immediately after the operation
switch is turned on or modes are
cleared or reset.
Select [Program No.10] to use the set-
tings stored in Program No.10 as
the initial mode.
Selecting a custom size
When selecting [Custom Size] as the
scan size, follow the procedure be-
low.
AAAA
Press [Custom Size] on the Scan Size
Setting screen.
Specifying Vertical and
Horizontal Measurements
(Length and Width)
A Enter the original size with the
number keys.
Select and enter values for [X1]
and [Y1], and then press the
{{{{#}}}}
key.
B Enter the scan starting point in
relation to the standard scan
starting point.
Select and enter values for [X2]
and [Y2], and then press the
{{{{#}}}}
key.
C Enter the scan size (area) with
the number keys.
Select and enter values for [X3]
and [Y3], and then press the
{{{{#}}}}
key.