Ricoh 220-240 V - Manual (Page 132)

Other Print Operations
122
3
Form Feed
This section gives instructions for operating the printer when there is no tray for
the selected paper size or type, or when paper loaded in the printer has run out.
Important
❒ The tray cannot be changed if the following functions are set:
• Duplex Print to a tray that does not support duplex printing
• Cover Sheet
• Slip Sheet
Note
❒ If form feed is selected for a tray with the following settings, you can change
the tray by canceling the settings:
• Duplex Print
Reference
If Auto Continue is selected, form fed paper is printed after a set interval. For
details, see p.168 “Auto Continue”.
Printing from a Selected Tray
If the printer does not have a tray for the selected paper size or paper type, or if
the selected paper loaded in the printer has run out, a caution message appears.
If this message appears, do the following procedure.
A
When the caution message appears, press [FormFeed].
B
Select the tray for form feed using the {U} or {T} key from those that ap-
pear on the display panel, and then press the {OK} key.
If you want to print after adding paper to the tray, select the tray after loading
the correct paper.
The printer prints using the selected tray.
Note
❒ If a tray with a smaller paper size is selected, the print job may be cut short,
or other problems may occur.