Ricoh 220-240 V - Manual (Page 41)

Using the Standard TCP/IP Port
31
1
M
Enter the printer name or IPv4 address in the [Printer Name or IPv4 Address]
box.
The [Port Name] text box automatically obtains a port name. Change this name
if necessary.
When screen for Device selection appears, select “RICOH NetworkPrinter
Driver C Model”.
N
Click [Next >].
O
Click [Finish] in the [Add Standard TCP/IP Printer Port Wizard] dialog box.
The installation start dialog box reappears.
P
Check that the port of the selected printer is displayed in [Port:].
Q
Configure the default printer as necessary.
R
Click [Continue].
The printer driver installation starts.
S
After the installation is completed, select one of the options to restart the
computer either now or later, and then click [Finish].
Restart the computer to complete installation.
Note
❒ Auto Run may not work with certain operating system settings. If this hap-
pens, launch “Setup.exe” on the CD-ROM root directory.
❒ To stop installation of the selected software, click [Cancel] before installa-
tion is complete.
Reference
A message appears if there is a newer version of the printer driver already
installed. If there is, you cannot install the printer driver using Auto Run.
If you still want to install the printer driver, use [Add Printer]. See p.61 “If a
Message Appears during Installation”.