Ricoh 220-240 V - Manual (Page 235)

Remote Maintenance by telnet
225
6
bonjour(rendezvous)
Use the “bonjour(rendezvous)” command to display bonjour(rendezvous)-related settings.
❖ View settings
Bonjour settings are displayed.
msh> bonjour
❖ Bonjour service name setting
You can specify the bonjour service name.
msh> bonjour cname “computer name”
• The computer name can be entered using up to 63 alphanumeric characters.
❖ Bonjour Installation location information setting
You can enter information about the location where the printer is installed.
msh> bonjour location “location”
• Information about location can be entered using up to 32 alphanumeric characters.
❖ Setting order of priority for each protocol
• diprint
msh> bonjour diprint [0–99]
• lpr
msh> bonjour lpr [0–99]
• ipp
msh> bonjour ipp [0–99]
You can specify the order of priority for “diprint”, “lpr”, and “ipp”. Smaller
numbers indicate higher priority.
❖ IP TTL setting
msh> bonjour ip ttl {1-255}
You can specify the IP TTL (the number of routers a packet can pass through).
Note
❒ The default is 255.
❖ Resetting the computer name and location information
You can reset the computer name and location information.
msh> bonjour clear {cname | location}
• cname
Reset the computer name. The default computer name will be displayed
when the computer is restarted.
• location
Reset the location information. The previous location information will be deleted.
❖ Interface configuration
msh> bonjour linklocal “interface_name”
• If many types of interface are installed, configure the interface that com-
municates with linklocal address.
• If you do not specify an interface, the Ethernet interface is automatically selected.
• wlan can be specified only when the IEEE 802.11b interface is installed.
Interface Interface configured
ether Ethernet interface
wlan IEEE 802.11b interface