Wins – Ricoh 220-240 V User Manual
Page 261
Remote Maintenance by telnet
251
6
wins
Use the “wins” command to configure WINS server settings.
❖ Viewing settings
msh> wins
• If the IPv4 address obtained from DHCP differs from the WINS IPv4 ad-
dress, the DHCP address is the valid address.
❖ Configuration
msh> wins “interface_name” {on | off}
• {on} means “active” and {off} means “inactive”.
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11b interface is installed.
❖ Address configuration
Use the following command to configure a WINS server IP address:
msh> wins “interface_name” {primary|secondary} “IP address”
• Use the “primary” command to configure a primary WINS server IPv4 ad-
dress.
• Use the “secondary” command to configure a secondary WINS server IPv4
address.
• Do not use “255.255.255.255” as the IPv4 address.
❖ NBT (NetBIOS over TCP/IP) Scope ID Selection
You can specify the NBT scope ID.
msh> wins “interface_name” scope “scope ID”
• The scope ID can be entered using up to 31 alphanumeric characters.
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11b interface is installed.
Interface name
Interface configured
ether
Ethernet interface
wlan
IEEE 802.11b interface
Interface name
Interface configured
ether
Ethernet interface
wlan
IEEE 802.11b interface