Omron NT20M - Manual (Page 28)

24
String Attributes Here you set the size, scale, and attributes for character strings that have
been input.
1, 2, 3... 1. Set the size to be used for each 1-byte character.
2. Set the scale factor for the characters. NT600M strings can be set to
64X in addition to the ones shown in the above display.
3. Set display attributes. “Spot” is for flashing characters in reverse video.
Display attributes will be displayed on the computer screen as shown
below. (Although the contrast of most displays in this manual is re-
versed, the contrast of these examples is the same of that on the
screen.
Normal Flashing
Inverse Spot (Inverse Blinking)
4. Press the Enter Key after checking the settings.
A display for designating string position will appear next.
Designate the display position for the string.
1, 2, 3... 1. A rectangular guide box showing the size of the input character string
will be displayed. The guide box is displayed according to the number of
characters input to that point, and the scale which has been set. Set the
display position on the screen with the direction keys. By operating the
direction keys while pressing the Shift Key, you can move the guide box
16 dots at a time. The X and Y coordinates of the display position (the X
and Y coordinates of the lower left-hand corner of the guide box) are
Designating Display
Position
Inputting Character Strings Section 2-1