Omron NT20M - Manual (Page 51)

47
Touch Switch Settings
Switch
number The number of the switch being set. (The numbers, 0 to 255, are
used in common with lamps. The same number cannot be used
more than once.)
Frame Whether or not switch frames are to be displayed when switch
are displayed. If “No” is designated, the switches will be indicated
by dotted lines on the Support Tool display. Either or normal or
solid frame can also be designated.
Inverse Whether an inverse display will appear when the touch switch is
input.
Label Whether or not a label is to be attached to the switch.
Press the Enter Key after checking all of these settings. The label is input
next if label input has been designated.
Inputting the Label If you set label to “Yes,” the following display will appear. If you set label to
“No,” you will be returned to the Initial Touch Switch Display.
Input the label and press the Enter Key. You can also press the F3 Function
Key to input from a list of marks that have been created. Refer to page 22 for
details on the mark input procedure.
Touch Switches Section 2-5