Omron NT20M - Manual (Page 47)

43
2-4-2 Direct Connection Lamps
Creating Use the following procedure to create a direct connection lamp.
1, 2, 3... 1. Select LAMP from the Initial Edit Display, a list of the lamps already ex-
isting in the current screen will be displayed.
2. Specify the number to be used in the table. The numbers in this table
are not the lamp numbers. When a number is specified, a display to
specify either a rectangular or round lamp will appear.
3. Specify the lamp shape. A display will appear to draw the lamp.
4. If a rectangle was specified, specify the starting and ending points (diag-
onally opposed corners) of the rectangle. If a circle was specify, desig-
Lamps Section 2-4