Omron NT20M - Manual (Page 79)

75
3. You can move the cross-shaped cursor to the perimeter of the desig-
nated circle and then modify the radius and center point in the same
way as when creating new circles.
2-11 Continuous and Overlapping Screens
You can combine previously created multiple screens into a continuous
screens by linking them or into one screen by stacking them into overlapping
screens. To make continuous screens, first one screen is designated as the
parent screen, and then child screens and the screen scrolling unit are set for
the parent screen. To make overlapping screens, first one screen is desig-
nated as the parent screen, and then child screens are designated for the
parent screen.
Setting the Parent Screen On the Screen Selection Display, move the bar cursor to a screen number for
which no data is entered, and press F8 (continuous/overlapping screens).
If you designate a screen for which data is already registered, a message will
appear asking whether you want to delete that data. If you do want to delete
it, then press the Enter Key.
To return to the Screen Selection Display, press the Escape Key.
If the designated screen is already a parent screen, its contents (the child
screens) can be edited.
Specify whether the designated parent screen is to be used for continuous or
overlapping screens.
Continuous and overlapping screens are explained separately below.
Note In cases such as the following, a message will be displayed indicating that
screen data could not be created. If that happens, press any key and then
again select the child screens again.
Selecting Continuous or
Overlapping
Continuous and Overlapping Screens Section 2-11