Omron NT20M - Manual (Page 88)

84
3. Press the Escape Key to return to the Creation Display.
Copy F2 is used to copy a designated rectangular area on the creation display to
another position. This operation can be canceled at any point by pressing the
Escape Key.
Note The cursor may not be displayed on the screen when it overlaps with the
starting point, ending point, etc. If you are not sure of the position of the cur-
sor, move it with direction keys.
1, 2, 3... 1. If you press F2 (Copy), the following screen will be displayed.
2. Move the cursor with the direction keys, and then enter the starting point
with the Enter Key. The starting point you have entered will be displayed
in reverse video.
3. Designate the ending point for the area to be copied. The ending point
you have entered will be displayed in reverse video.
4. Use the direction keys to move the cursor, and then press the Enter Key
to copy the designated data to the cursor position.
Reference Copy F3 is used to copy a designated rectangular area on the reference display to
a designated position on the creation display.
Marks Section 2-14