Omron NT20M User Manual

Page 58

Advertising
background image

54

Display Settings

Set all the bar graph display attributes and press the Enter Key.

Direction

Whether the bar is to be displayed in the normal direction or the
reverse direction. (See note 1.)

Width

The width of the bar graph. The width must be 3 dots or greater
to set a frame. The width must be 8 dots or greater when
displaying horizontal bars from the top of the screen or when
displaying vertical bars from the right of the screen.

Graph Frame

Whether or not a graph frame showing 100% is to be displayed.

Disp sign

Whether or not a negative (–) sign is to be displayed. If a
negative sign is used, the bar graph can be displayed in the
reverse direction for negative values. (See note 2.)

100% value

The value of the denominator for percentage calculations. You
cannot set numerals of 0 or less as the 100% value.

Display %

Whether or not the result of percentage calculations is to be
displayed as numerals.

Size of %

Set the character size of numerals for when percentages are
displayed.

Scale

Set the scale factor for the percentage display. The NT600M can
be set to 64X in addition to those shown above.

Note 1. Horizontal bar graphs can be displayed left to right or right to left. Vertical

bar graphs can be displayed top to bottom or bottom to top.

2. If a display sign (negative value) is specified, the center of the bar will be

set as 0% and the right or top of the bar will be set as 100% (for normal
displays). (The center will be one dot up or to the left of center for odd-
sized bars.) Examples are shown below.

Displaying 60%

Without sign

With sign

60%

60%

Bar Graphs

Section 2-6

Advertising
This manual is related to the following products: