Quantum ATL M-Series - Manual (Page 111)

Chapter 5 Running Diagnostic Programs
Running the Move Location Test
ATL M-Series User’s Guide 93
the selected number of test cycles. The home location depends on
whether the destination is a tape drive or a magazine slot:
• If the destination is a tape drive, the home location is slot 1 of
the level 1 left magazine.
• If the destination is a magazine slot, the home location is the
first installed tape drive.
To run the Move Location test:
1 Access the Diagnostics Menu screen (see Accessing the
Diagnostics Menu Screen on page 85).
2 Press the Up and Down buttons to select General .
3 Press Select .
The GUI displays the Diags: General screen (see figure 48 on
page 87).
4 Press the Up or Down buttons to select Move Location .
5 Press Select .
The GUI displays the Diag: Move-Location screen (see
figure 54 ).
Figure 54 Sample
Diag: Move-Location
Screen