Figure 55 diag: move location screen – Quantum ATL M-Series User Manual
Page 112
Chapter 5 Running Diagnostic Programs
Running the Move Location Test
94
ATL M-Series User’s Guide
6
Press the
Up
and
Down
buttons to select the destination for the
robotic hand.
7
Press
Select
.
The GUI displays the
Diag: Move Location
screen, which
prompts you to set the cycle count (see
). The
rightmost number is highlighted.
Figure 55 Diag: Move
Location Screen
8
Press the
Up
and
Down
buttons to change the highlighted
number.
9
Press
Left
to move the highlight to the next number.
10
Repeat steps
and
as necessary until the desired cycle count
number is displayed.
11
Press
Right
until the cursor is all the way to the right and the
Select
button appears.
12
Press
Select
to set the cycle count, or press
Cancel
to return to
the
Diags: General
screen without running the
Move Location
test.
Note:
Setting the cycle count to
0000
causes the test to run
continuously.