Quantum ATL M-Series - Manual (Page 80)

Chapter 3 Changing the Library Configuration
Changing the Serialization Setting
62 ATL M-Series User’s Guide
Changing the Serialization Setting
3
The Serialization option controls how the library returns the tape
drive serial number when a Read Element Status is requested.
When Serialization is set to On , the tape drive serial number is
returned in a format compatible with Quantum ATL Prism
products. When Serialization is set to
Off
, the tape drive serial
number is returned in a vendor unique format. This setting is only
valid when Emulation is set to ATL M2500 or ATL 1500 (see
Changing the Emulation Setting on page 59).
To enable or disable drive serialization:
1 Access the Configuration screen (see Accessing the
Configuration Screen on page 53).
2 Press the Up or Down buttons until Serialization is highlighted.
3 Press Select .
4 Use the Up or Down buttons to select the desired Serialization
setting. The available settings are Enabled and Disabled .
5 Press Select .
To return to the Configuration screen without changing the
option setting, press Cancel .
6 Press Main to return to the main screen.
Note: The default setting is Disabled .
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.