Caution, Warning, Appliance set-up – Quadra-Fire 2100 Millennium Wood 21M-ACC User Manual

Page 19

Advertising
background image

May 5, 2011

7039-131H

Page 19

2100 Millennium Wood Stove (ACC)

R

NOTE: When the speed control is turned clockwise,

it will click on to high speed. Continue to turn the

speed control clockwise to decrease the speed. At

full clockwise, the blower should blow gently, but

should not stop.

1. With the appliance plugged in, turn the speed

control knob to slow (full clockwise).

2. With a small screwdriver, adjust the blower speed

by turning the adjustment mechanism through the

hole on the side of the speed control.

3. Adjust the speed so the blower runs slowly, but

does not stop. Turn clockwise to slow the blower

and counterclockwise to increase the speed.

The blower speed control for this unit is adjusted at the factory,

and normally does not require further adjustment.

B. Adjusting The Blower Speed Control

A. Door Handle Assembly

1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install second washer(s) as shown in

Figure 19.1.

4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam

over shaft

6. Install locknut but do not overtighten, the handle

needs to move smoothly.

7. Install spring handle turning in a counter-clockwise

motion to

required 2 inch (51mm) clearance loca-

tion on door handle rod.

Figure 19.1.

Figure 19.1

CAUTION

• Do NOT overtighten lock nut.

• Door handle needs to move smoothly.

Locknut

Door Cross Section

(example)

Latch Cam

Spacing

Washers

Square Key

Door Handle

Spring

Handle

2 inch (51mm) clearance

required from bend in door

handle rod to end of spring

handle.

WARNING

HOT. Injury Risk.

• Maintain clearance between bend of

door handle rod and spring handle.

• Spring handle will get hot and may

cause injury.

7

Appliance Set-Up

Advertising