Toshiba RAV-SM561AT-E - Manual (Page 49)

– 49 –
RAV-SM561BT-E, RAV-SM801BT-E, RAV-SM1101BT-E, RAV-SM1401BT-E
Operation section
Push each button to select a desired operation.
• The details of the operation needs to be set up once, the same states are used by pushing
button.
1
Fan mode button
Selects a fan mode.
2
Timer set button
TIMER SET button is used when the timer is
set up.
3
Check button
CHECK button is used for check operation.
During normal operation, do not use this
button.
4
Fan button
FAN button is used when a fan which is sold on
the market or etc. is connected.
• If “No function” is displayed on the remote
controller when pushing the FAN button, a
fan is not connected.
5
Filter reset button
Resets (Erases) “FILTER ” display.
6
UNIT and AUTO flap button
No function
7
Operation lamp
Lamp is lit during the operation. Lamp is off
when stopped.
It flashes when operating a protection device
or abnormal occurred.
8
button
When the button is pushed, operation starts,
and it stops by pushing the button again.
When the operation stops, the operation lamp
and all displays disappear.
9
Operation select button
Selects operation mode.
10
Set up temperature button
Adjusts required room temperature.
Set required set temperature by pushing
or .
FILTER UP/DOWN button
(No function display)
OPTION :
Remote controller sensor
Usually the TEMP. sensor of the indoor unit mea-
sures a temperature. A temperature around the
remote controller can also be measured.
For details, contact the dealer from which you have
purchased the air conditioner.
UNIT
SET CL
1
2
10
9
7
8
3
4
5
6