Texas Instruments TMS320TCI6486 - Manual (Page 50)

EMAC Functional Architecture www.ti.com
2.8.2.2 Writing Data to a PHY Register
The MDIO module includes a user access register (USERACCESSn) to directly access a specified PHY
device. To write a PHY register, perform the following:
1. Ensure that the GO bit in the USERACCESSn register is cleared.
2. Write to the GO, WRITE, REGADR, PHYADR, and DATA bits in USERACCESSn corresponding to the
desired PHY and PHY register.
3. The write operation to the PHY is scheduled and completed by the MDIO module. Completion of the
write operation can be determined by polling the GO bit in USERACCESSn for a 0.
4. Completion of the operation sets the corresponding bit in the USERINTRAW register for the
USERACCESSn used. If interrupts have been enabled on this bit using the USERINTMASKSET
register, then the bit is also set in the USERINTMASKED register and an interrupt is triggered on the
DSP.
2.8.2.3 Reading Data From a PHY Register
The MDIO module includes a user access register (USERACCESSn) to directly access a specified PHY
device. To read a PHY register, perform the following:
1. Ensure that the GO bit in the USERACCESSn register is cleared.
2. Write to the GO, REGADR, and PHYADR bits in USERACCESSn corresponding to the desired PHY
and PHY register.
3. The read data value is available in the DATA bits of USERACCESSn after the module completes the
read operation on the serial bus. Completion of the read operation can be determined by polling the
GO and ACK bits in USERACCESSn. Once the GO bit has cleared, the ACK bit is set on a successful
read.
4. Completion of the operation sets the corresponding bit in the USERINTRAW register for the
USERACCESSn used. If interrupts have been enabled on this bit using the USERINTMASKSET
register, then the bit is also set in the USERINTMASKED register and an interrupt is triggered on the
DSP.
2.8.2.4 Example of MDIO Register Access Code
The MDIO module uses the USERACCESSn register to access the PHY control registers. Software
functions that implement the access process include the following four macros:
PHYREG_read (regadr, phyadr ) Starts the process of reading a PHY register
PHYREG_write(regadr, phyadr, data ) Starts the process of writing a PHY register
PHYREG_wait ( ) Synchronizes operation (makes sure read/write is idle)
PHYREG_wait Results (results ) Waits for read to complete and returns data read
It is not necessary to wait after a write operation, as long as the status is checked before every operation
to make sure the MDIO hardware is idle. An alternative approach is to call PHYREG_wait () after every
write, and PHYREG_wait Results () after every read, then the hardware can be assumed to be idle when
starting a new operation.
50 C6472/TCI6486 EMAC/MDIO SPRUEF8F – March 2006 – Revised November 2010
Submit Documentation Feedback
Copyright © 2006–2010, Texas Instruments Incorporated