Safety, Important safety instructions, Read and save these instructions – Thermador PRO-HARMONY PRL30 User Manual
Page 4: Please read carefully, 30" gas model, 36" gas models, Warning, Caution, Caution — all models, Tested in accordance with
English 2
This manual contains important Care and Use information
for all Thermador Professional® Ranges. When using this
manual, it is critical that you know the model number of
your range, as some information will be unique to each
range. The model number may be found on the rating plate
located on the range as identified on page 33 of this
manual. The charts on the following pages summarize the
various range models and identify the features of each
range.
Safety
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Gas and Electrical Requirements and
Grounding Instructions
PLEASE READ CAREFULLY
30" Gas Model:
120 volts, 60 Hz., 10 Amp electrical circuit required.
36" Gas Models:
120 volts, 60 Hz., 10 Amp electrical circuit required. 36"
gas range with electric griddle - 20 Amp circuit required.
WARNING:
ALWAYS DISCONNECT THE ELECTRICAL
PLUG FROM THE WALL RECEPTACLE
BEFORE SERVICING THIS UNIT
It is recommended that a dedicated circuit servicing this
appliance be provided.
The use of gas cooking appliances results in the production
of heat and moisture.
CAUTION:
FOR PERSONAL SAFETY, THIS APPLIANCE
MUST BE CONNECTED TO A PROPERLY
GROUNDED AND POLARIZED ELECTRICAL
POWER SUPPLY.
WARNING:
To avoid possible burn or fire hazard, a
backguard designed specifically for this range
must be installed whenever the range is used.
See Installation Instructions for electrical requirements and
grounding instructions.
It is the personal responsibility and obligation of you, the
user, to have this appliance connected to the electrical
power supply in accordance with the National Electrical
Code and/or applicable local codes and ordinances by a
qualified electrician.
CAUTION — ALL MODELS:
IN CASE OF AN ELECTRICAL FAILURE
If for any reason a gas control knob is turned ON
and there is no electrical power to operate the
electronic igniters on the range's cooktop
burners, turn OFF the gas control knob and wait
5 minutes for the gas to dissipate before lighting
the burner manually.
To light the burners manually, carefully hold a
lighted match to the burner ports and turn the
gas control knob to
.
During a power failure,
you can use the standard cooktop burners, but
each must be lit with a match.
DO NOT attempt to light the two left burners
manually. These burners are equipped with the
ExtraLow
®
feature and cannot be lit manually.
TESTED IN ACCORDANCE WITH:
•
ANSI Z21.1 for Household Gas Appliances
•
UL858 for Household Electric Ranges
•
CAN/CSA-22.2 No. 61-M89 for Household Cooking
Ranges
•
CAN/CGA 1.1-M81 Domestic Gas Ranges
Check your local building codes for the proper method of
installation. In the absence of local codes, this unit should
be installed in accordance with the National Fuel Gas Code
No. Z223.1 current issue and the National Electrical Code
ANSI/NFPA No. 70 current issue or the Can - B149