3 raid-0 (2) – Toshiba PORTEGE M400 User Manual
Page 129
3.3 Check of the RAID configuration
3 Tests and Diagnostics
The RAID is not configured by two drives in the following display, because there are two
LDs (LD0 and LD1).
TOSHIBA RAID / RAID Information Display Rev xx.xx.xxxx
Copyright(c) 2005 TOSHIBA CORPORATION. All Rights Reserved.
Level
Status Capacity
LD0 RAID-0 OPTIMAL
xxGB
Write cache
: Enable
Degrade Bootup
: Yes
MBR Protection
: Disable
S.M.A.R.T
: Enable
LD1 RAID-0 OPTIMAL
xxGB
Write cache
: Enable
Degrade Bootup
: Yes
MBR Protection
: Disable
S.M.A.R.T
: Enable
Port Assign Status
Size Model
Rev
0
LD0-0 ONLINE
xxGB FUJITSU--------------
xxxxxxx
1
LD0-0 ONLINE
xxGB FUJITSU--------------
xxxxxxx
< RAID: RAID-0 >
3.3.2.3 RAID-0
(2)
When there is one LD and “RAID-0 Critical” is displayed in the shown below, it is
judged that the RAID is configured by two drives.
Level
Status
Capacity
LD0 RAID-0 CRITICAL xxGB
Stripe Size
: 64KB
Write cache
: Enable
MBR Protection :
Disable
S.M.A.R.T
:
Enable
Port Assign Status
Size Model Rev
0 LD0-0
ONLINE xxGB
FUJITSU-------------- xxxxxxx
1 NODRIVE
< RAID: not OPTIMAL >
PORTEGE M400 Maintenance Manual (960-541)
[CONFIDENTIAL]
3-11