Toshiba PORTEGE M400 - Manual (Page 292)

4 Replacement Procedures 4.19 MDC
4.19 MDC
Removing the MDC
The following describes the procedure for removing the MDC. (See Figure 4-35 and 4-36.)
1. Remove the following screws securing the MDC.
• M2.0×4.0B BIND
screw
×2
2. Remove the MDC from the connector CN3010 on the system board.
3. Disconnect the MDC cable from the connector on the MDC.
M2.0x4.0B BIND
M2.0x4.0B BIND
MDC
MDC cable
CN3010
Figure 4-35 Removing the MDC
4-54 [CONFIDENTIAL] PORTEGE M400 Maintenance Manual (960-541)