Toshiba PORTEGE M400 - Manual (Page 213)

3.30 Sound Test program 3 Tests and Diagnostics
PORTEGE M400 Maintenance Manual (960-541) [CONFIDENTIAL] 3-95
(2) Audio CD
Insert an audio CD and the following menu appears in the display.
CD/DVD TEST IN PROGRESS XXXXXXXX xxxxxxx DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] : test end
[Ctrl]+[C] : key stop
SUB-TEST : XX
PASS COUNT : XXXXX
ERROR COUNT: XXXXX
WRITE DATA : XX READ DATA : XX
ADDRESS : XXXXXX STATUS : XXX
CD Sound track number (01-98 : Track) ?
Drive # = 0, ATAPI status =00
Command = XX
[[Block address = XXXXXXXX]]
[[Block length = XXXXXXXX]]
Final : Block address = XXXXXXXXX
Select the track number you want to test and press Enter twice.
The following message appears in the display and selected track is played.
Play start CD sound !
Press any key <play stop>
After pressing any key, the music stops and the display returns to the selection menu of the
track number.
NOTE: When the CD-ROM test is executed, “ALL DEVICE” must be selected in the
[Device Config.] of the BIOS SETUP. If the “ALL DEVICE” is not selected,
music can not be played.
3.30.4 CD Sound (Legacy)
To execute the CD Sound (Legacy) test, select 4 and press Enter.
CAUTION: Sound (Legacy) test is not supported in this model.