Toshiba PORTEGE M400 - Manual (Page 313)

4.27 Fingerprint sensor board (NF board) 4 Replacement Procedures
4.27 Fingerprint sensor board (NF board)
Removing the Fingerprint sensor board (NF board)
The following describes the procedure for removing the fingerprint sensor board (NF board).
(See Figure 4-48.)
1. Remove the following screw and fingerprint sensor board.
• M2.5×4.0B
FLAT HEAD screw
×1
2. Disconnect the fingerprint sensor cable from the connector CN9560 on the finger
print sensor board.
M2.5x4.0B FLAT HEAD Fingerprint sensor board
Fingerprint
sensor cable
CN9560
Figure 4-48 Removing the fingerprint sensor board
Installing the Fingerprint sensor board (NF board)
The following describes the procedure for installing the fingerprint sensor board (NF board).
(See Figure 4-48.)
1. Connect the fingerprint sensor cable to the connector CN9560 on the finger print
sensor board.
2. Install the fingerprint sensor board and secure it with the following screw.
• M2.5×4.0B
FLAT HEAD screw
×1
PORTEGE M400 Maintenance Manual (960-541) [CONFIDENTIAL] 4-75