UTStarcom CDM 1080 - Manual (Page 40)

C
H
4
77
SETTINGS
C
H
4
76
SETTINGS
1 Press [MENU], then select “Settings & Tools”
menu, then press “Call Settings” then select
“Voice Services”, then press “Train
Word”.
TRAIN WORD
2 Under “Yes”, “No”, “Wake-Up”.
“Please listen closely to hear instructions” will be
displayed and you will hear “Now training control
words. Please say the word”. Say word. You will
hear “Again”. Say word again. You will hear
“Training word successful”.
To undo voice recognition, select a word you want
to undo then press [UNDO]
.
3 Under “Undo Train All”.
“Undo voice recognition for all procedures?”
will be displayed. Press [OK] to undo all
trained words.
Train allows you to use Control words to make a call without using
the keypad. Use to train or untrain the Voice Recognition with the
control word, “Yes”, “No” or “Wake-Up”.
5 To play voice memo, select the message you want
to play then press [PLAY].
To send voice memo, select the message you want
to send then press
[SEND] to access the “New
Pix Msg” see “New Pix Msg” on page 100.
If saved voice memo, press [OPTIONS] to select
one of the following options:
l Set As Ringtone
l Set As Ringer ID
l Rename
l Erase
l Erase All
1 Press [MENU], then select “Settings & Tools”
menu, then press “Call Settings” then select
“DTMF Tones”.
3 To save, press [OK].
DTMF TONES
2 Select one of the following with the Navigation Key.
Normal
Short
Off
l
l
l
To adjust tone length: