Univex PRV-LX1 - Manual (Page 14)

14
PRV-LX1
En
Front Panel Facilities
Names of Parts
No.
1
2
3
4
5
6
7
8
9
Name
STANDBY/ON button
Display sections
PLAY/REC indicator
DISC indicator
EJECT button ( 0)
Drive 2 cosmetic panel
DVD1, DVD2, HDD (Hard disk Drive)
indicators
DRIVE SELECT button
PREVIEW button
Function
When the unit is in the standby condition, pressing this button causes the
power to come on; the power indicator (to the left of the button) changes
from orange to green. The main display section indicates system startup.
After system startup is completed, the unit enters “idling condition,” and as
the unit’s display changes to show the current time, the STOP button lights.
When the unit is in the standby condition, if this button is pressed while
holding the STOP button depressed, the Function Menu’s setting values
will be reset to their factory defaults, and the power will then turn ON.
If the button is held depressed for one second or more when the unit is in
the idling condition, the unit will perform system shutdown, followed by
return to the standby mode (the power indicator will change from green to
orange). In the event operation becomes unstable and manual forced
shutdown is required, hold the button depressed for four seconds or more.
Lights to indicate operating state of DVD1/DVD 2 drive.
Appears green during PLAY mode, and orange during REC mode.
Located to the right side of DVD1/DVD 2, this indicator light (orange) to
indicate that a disc is loaded. (*1)
Press to open/close disc tray. The DISC indicator flashes from the time
the button is pressed until the disc tray closes fully.
This space is provided to allow the addition of a second DVD drive. When
an additional writer (PRA-DW11) is added here, it is considered “DVD2.”
Some models are factory equipped with twin-DVD-drive.
* For information on availability of twin-DVD models, consult your dealer.
These indicators light to show which drive has been selected with the
DRIVE SELECT button (the indicator for the selected drive lights green).
Use to select the playback source and destination drive for recording. The
selection changes in the order HDD (Hard disk Drive)
= DVD1 = DVD2
= DVD1&2. When a drive is selected, the corresponding indicator lights
(green). When DVD1&2 is selected, DVD1 is designated as the playback
source.
When this button is pressed with the unit in the idling condition, a
preview image/sound of the selected input (following encode and decode
processing) is supplied to all output connectors except DV; when the
button is pressed again, the unit returns to idling condition.
2 3 4 5
4
3
5
6
7 8 9 10 11 12 13
14 15 16 17 18 19 20 21 22 23
1
24 25 26
*1 A disc created on the PRV-LX1 that contains many titles may take dozens of seconds to recognize when loaded. The DISC
indicator flashes and the disc recording and playback cannot be started during disc recognition.
Twin-DVD-drive model or single-DVD-drive
model added PRA-DW11 (optional)