Univex PRV-LX1 - Manual (Page 35)

35
PRV-LX1
En
Selecting Recording Destination
The currently selected recording destination (also the
playback source) will be displayed on the front
panel’s central indicator (DVD1, DVD2, HDD
indicator). The [Drive] command on the Function
Menu’s STATUS section also indicates the currently
selected recording destination/playback source. Use
the front panel’s DRIVE SELECT button, or the
[Drive] command in the Function Menu’s STATUS
section to select the recording destination. However,
note that the DRIVE SELECT button is disabled
during display of the Function Menu.
When the “HDD” is selected, recording to
performed to HDD only. If only 1 DVD-R/RW writer is
installed, “DVD1” will be selected; if two writers are
present, either “DVD1” or “DVD2”, or “DVD1&2”
can be selected as the recording destination.
When “DVD&HDD” is selected using the EDIT
section
= [Project] = [Record/Name] = [Record
To] command, data is recorded both to the DVD disc
and hard disk simultaneously, and hard disk
recording remains stored even after the DVD disc
has been removed.
STATUS section = [Drive] (single-DVD-drive model)
STATUS section
= [Drive] (twin-DVD-drive model)
When a disc is removed before finalizing, the data
recorded so far remains on the hard disk. A new
project is automatically created when this disc is
reinserted and additional data that is recorded is
saved to this project. Thus data recorded prior to
removal and data recorded after reinsertion are
saved to different projects.
Note:
When a disc is inserted and a recording is made,
[Record To] setting can no longer be changed.
The [Record To] setting is saved for each drive and
can be changed when drive selection changed.
EDIT section = [Project] = [Record/Name]
= [Record To]
When recording to hard disk drive, this recorder
performs internal management of recorded data
(clips) in units called “projects.” Multiple clips (up to
a maximum of 255) can be recorded in a single
project, and so long as a project is not changed, clips
can be recorded continuously within a single project.
When you wish to classify your recorded data in
multiple groups, change the project by using the
[Project] command on the STATUS section, and
continue recording.
STATUS section
= [Project]
Recording