Univex PRV-LX1 - Manual (Page 33)

33
PRV-LX1
En
Recording
The recording function involves inputting video/audio
signals from a VTR or other video playback device
(“external VTR”), converting those signals to data
compatible with the DVD video format, and
recording that data on the hard disk or a DVD-R/RW
disc. A playback video/audio signal is simultaneously
output. If the SET UP section [Operation]
= [Video
Settings]
= [Composite Out] is set to “Source
Monitor”, the input image will be passed through
during recording as well (see page 32). In addition, in
the event this command is set to “Decoder Out”,
the output signal will be the encoded/decoded
version of the original input video/audio signal.
Note 1:
The playback video signal is delayed about 4 seconds
with respect to the input signal due to the time
required for encoding and decoding.
Note 2:
Recording will not begin if a copy-guard protected
input signal is detected.
Note 3:
If [Composite Out] is set to “Source Monitor”
(pass-through output), when OSD is set to ON during
recording, the video and audio will switch to
“Decoder Out” (encode/decode output).
Note 4:
Turn off the power of the recorder and then turn it
back on again if the disc does not come out even
when a drive error has occurred.
Drive indicators
Selecting the TV System Mode
Select the TV system mode for recording. When [TV
SYSTEM] is selected on the STATUS section of the
Function Menu, the selectable TV systems are
displayed. Using the CURSOR button and ENTER
button, select either “NTSC” or “PAL”. When
changing from the currently selected system, a
confirmation dialogue box will be displayed.
STATUS section = [TV System]