Univex PRV-LX1 - Manual (Page 68)

68
PRV-LX1
En
Project Editing
Copying a Project
Using the EDIT section
= [Project] = [Copy
Project] command, the currently selected project
can be copied to a new project.
The project name that automatically appears in the
EDIT Section’s [Project]
= [Copy Project] = [Copy
To] command will be affixed with a numeral to
distinguish it from the current default project (for
example, “cX” + current project name, where the
“X” is a numeral). When the project copy command
is executed, the copied project name appear with
the automatically changed numeral. However, this
automatically processing will not be performed if the
project name has been changed.
Note 1:
To input project names, connect a keyboard to the
MOUSE/KEYBOARD USB jack.
Note 2:
Japanese cannot be used in project names.
EDIT section = [Project] = [Copy Project]
= [Copy To]
Copying Clips
Use the EDIT section
= [Project] = [Copy Clip]
command to copy clip in project specified by [Source
Drive] command to currently selected project.
“HDD”, “DVD1” and “DVD2” can be selected.
“DVD2” appear only if connected.
Using EDIT section = [Project] = [Copy Clip] =
[Source Drive] for selecting drives
Executing Copy command on EDIT section
= [Project] = [Copy Clip]
Recorded data is also managed as a project when
recording directly to DVD disc, but editing is not
possible in this case.
By using the EDIT section
= [Project] = [Record/
Name]
= [Record To] command to select “DVD &
HDD”, the recorded images will be preserved on the
hard disk drive even after finalizing and removal of
the DVD, thus allowing later editing if desired.
Note 3:
When a disc is removed before finalizing, the data
recorded so far remains on the hard disk. A new
project is automatically created when this disc is
reinserted and additional data that is recorded is
saved to this project. Thus data recorded prior to
removal and data recorded after reinsertion are
saved to different projects.
EDIT section
= [Project] = [Record/Name]
= [Record To]