Univex PRV-LX1 - Manual (Page 89)

89
PRV-LX1
En
Message Display
Item
TV System
TV System
Network
Network
Text entry
HDD format
HDD format
HDD check
USB HDD format, check
USB HDD format
Eject
Initialize
Initialize
Initialize
Initialize
Initialize
Finalize
Finalize
Finalize
Finalize
Finalize
Copy
Copy
Copy
Copy
Copy
Copy
Copy
Copy
Copy
Copy
Copy
Message
Switch TV System
After 10 seconds, TV System will return to previous
mode.
Network Error, Check Connection.
Network Settings Error.
Input Parameter Error.
Delete All User Data?
Please eject a disc from drive, before formatting
HDD.
Start File System Check?
No USB HDD.
Format USB HDD(******)
Do you finalize the disc to allow playback on
other players?
This is not a DVD-RW disc.
There is no disc.
This disc has been finalized. Reinitialize to
record.
Disc initialization failed.
There is video recording data in this disc.
The disc needs to be finalized.
Cannot be finalized.
There is no disc.
The size of menu is too large.
Disc finalization failed.
The disc needs to be initialized.
Target is not ready or illegal disc.
Source is not ready or illegal disc.
There is no disc.
This is not a blank disc.
Not enough space to copy.
Not enough space to copy.
The disc contains data.
The disc needs to be finalized.
No Image File(HDD) exists.
Copy disc failed.
Comment
Switches TV system mode. When [OK] is pressed, TV system
is switched temporarily.
When [OK] is pressed, TV system setting is maintained. Either
press [Cancel] or wait 10 seconds to return to former setting.
Check Ethernet cable connection.
There is something the matter with the network. Check that
the IP address, subnet mask and gateway address are correct.
The entered value is outside the range. Enter the correct value.
Displayed at start of hard disk formatting operation. All data
previously recorded on the hard disk drive will be erased.
The hard disk cannot be formatted when there is a disc in the
drive. Eject the disc and try again.
Displayed at start of hard disk check. Depending on the
condition of the hard disk drive, this operation may require
several minutes to complete.
The USB HDD cannot be recognized.
Appears when USB HDD formatting starts.
Delete all data on a USB HDD.
When [Finalize] is pressed, the disc is finalized and then ejected.
If [Eject] is pressed, the disc is ejected without being finalized.
Only DVD-RW discs can be initialized.
No disk has been loaded. Insert a DVD-RW disc.
Press the Initialize button to reinitialize the disc.
DVD disc initialization failed. A disc fault may have occurred.
Press the Initialize button to initialize the disc.
Finalize the disc.
This disc cannot be finalized.
No disc has been loaded in the drive.
The attached menu size is too large for the current project title
composition. Change to a menu design with more buttons on
each page of the menu. Also, by changing to title menu, it may
be possible to construct the menu with a smaller volume.
DVD disc finalization failed. A disc fault may have occurred.
Since the DVD-Video was not finalized, playback may not be
possible on some players.
The DVD-RW disc has already been recorded.
To rerecord the disc, initialize it once again.
Check target disc.
Check the copy source. A copyrighted DVD disc or a DVD-RW
disc with CPRM cannot be selected as a copy source.
No disc has been loaded. Insert a disc.
When using DVD-R disc, insert an unused disc.
The target disc lacks sufficient open capacity to copy.
Not enough free space on the hard disk to store copied data.
Not a blank or initialized disc.
Copy source disc must be finalized.
No image file on the hard disk.
Disc copying failed. A disc fault may have occurred.
7 Messages displayed in dialogue box during Function Menu operations