VTech LS6245 - Manual (Page 82)

78
Appendix
expand your telephone system
The handset provided with your telephone system is pre-registered as
hANDSeT. Additional handsets registered to the telephone system are
assigned in sequential order. If you register another new handset to your
telephone system, the new registered handset is assigned hANDSeT 2.
This telephone system accommodates up to 12 handsets.
Add and register a handset (optional)
You can add new handsets ( LS6204, purchased separately) to your
telephone system, but each handset must be registered with the telephone
base before use. When first purchased, each expansion handset shows
NoT ReGISTeReD. You may need to charge the handset before
registering to the telephone base. For more details on battery charging, see
the table on page 5.
To register a handset:
Place the unregistered handset in the telephone base. If To register,
press hoLD on BASe for 4 sec does not appear on the handset screen
after a few seconds, remove the handset and place it in the telephone
base again.
On the telephone base, press and hold
hoLD for about four seconds until
the telephone base displays Registering handset. The handset shows
Please wait... and it takes up to 60 seconds to complete the registration.
The handset shows hANDSeT X Registered (X represents the handset
number assigned) and you hear a beep when the registration completes.
1.
2.
If the registration fails, the handset shows NoT ReGISTeReD. To reset
the handset, remove the handset from the telephone base and place it back
in. Try the registration process again.
You cannot register a handset if any other system handset is in use.
•
•