VTech DS6321-2 - Manual (Page 18)

14
Bluetooth
Bluetooth setup
To use a Bluetooth enabled cell phone or headset with your DS6321/6322,
you must first pair and connect your Bluetooth device(s) with the telephone
base. All DS6321/6322 handsets can be used to make or answer on the cell
phone line.
Bluetooth wireless technology operates within a short range. When you pair
a Bluetooth cell phone or Bluetooth headset to the telephone base, move
closer to the telephone base to maintain sufficient signal strength.
Pair a cell phone
Before you begin, make sure that you have cellular coverage and your
Bluetooth enabled cell phone is not connected to any other Bluetooth device.
Refer to your cell phone user's manual to learn how to search for or add new
Bluetooth devices.
To pair and connect a cell phone:
Press MeNu/
SeleCT
on the handset when it is not
in use.
Press or to highlight
Bluetooth, then press
MeNu
/SeleCT.
Press or to highlight Add cellular, then press
MeNu
/SeleCT. The screen displays ADD CellulAR
Place cell phone next to base. Press SeleCT.
If there are already four paired devices on the
paired devices list, the screen will show Maximum
of 4 devices can be paired and prompt you to
replace an existing paired device (page 21).
Press
MeNu
/SeleCT. The screen displays
Please set your cell phone to search for devices,
then press SeleCT.
If a device is already connected to the telephone
base, the screen displays Connected device will
be temporarily disconnected. Press SeleCT.
Press
MeNu
/SeleCT to temporarily disconnect the
device and continue the pairing process.
Turn on the Bluetooth feature of your cell phone and
search for or add new devices.
Press
MeNu
/SeleCT to set the telephone base to
discoverable mode.
Once your cell phone finds
VTech DS6321/VTech
DS6322, press
MeNu
/SeleCT.
1.
2.
3.
•
4.
•
5.
6.
7.
Ans. system
Directory
Call log
Intercom
Bluetooth
ADD CELLULAR
Place cell
phone next to
base.
Press
SELECT
BLUETOOTH
Download dir
Add cellular
Add headset
Active devices
Please set your
cell phone to
search for
devices, then
press
SELECT