VTech DS6321-2 - Manual (Page 21)

17
Bluetooth
Headset A
paired to base.
Connect now?
Press
SELECT
Pair a headset (continued)
When the handset displays headset A paired to base.
Connect now? Press SeleCT, then press
MeNu
/SeleCT on the handset.
When you already have two devices on the active
devices list, the handset shows Maximum of 2
devices can be connected. You are prompted to
replace an existing device on the active devices list
(page 21).
When you already have one headset on the active
devices list, the handset shows only 1 headset
can be connected. You are prompted to replace an
existing device on the active devices list (page 21).
When a device is successfully connected, the
handset displays headset setup completed Device
connected and the corresponding status icon ( 1 or
2). The corresponding light on the telephone base
( DeVICe1 or DeVICe2) turns on.
Auto connection
When a device is successfully paired with the telephone
base but not connected, the handset displays
headset setup completed Device not connected and
then Auto-connect function enabled Press SeleCT.
You can press
MeNu
/SeleCT to exit. You can connect a
device manually (page 20).
9.
•
•
10.
Headset setup
completed
Device
connected
The pairing process may take up to one minute. If the pairing process fails,
try again.
If you put the handset back in the telephone base or charger while pairing,
the process discontinues and the handset returns to idle mode.
•
•
Headset setup
completed
Device not
connected
Auto-connect
function
enabled
Press SELECT