Visioneer MFC7050C - Manual (Page 105)

M E S S A G E C E N T E R
12-5
Messa
g
e
Center
Step 3: Activating Message Center Mode
Press Mode on the control panel until both the FAX and FAX/TEL
lights are on.
FAX
FAX/TEL
Message Indicators
Once you return home or to the office you can easily and quickly
see if any voice or fax messages have been stored in the Message
Center. There are two ways to determine if messages are stored.
If the VOICE and/or Fax Indicator lights are flashing, there is a
new message stored. Once a new voice message is played, the
VOICE indicator light stops flashing and stays on. And once a
new fax message is printed, the Fax indicator light will turn off.
Voice Fax
The LCD display will indicate the total number of incoming
VOICE and/or FAX messages stored in Message Center memory.
VOICE:03 FAX:02
Playing Voice Messages
Follow the steps below to listen to voice messages:
1 Press Play . Adjust Volume by pressing L or H .
All messages are played in the order they were recorded. The
display shows the number of the current message, and the total
number of messages.
2 Press (RWD) at the end of the message to repeat a
message. Press (FWD) to skip to the next message. You can
press and repeatedly until you reach the message you
want to play.
3 Press Stop to exit.
See
Setting Up the
Message Center
p. 12-3