Visioneer MFC7050C - Manual (Page 93)

T E L E P H O N E O P E R A T I O N
9-3
Dialing
Access Codes and Credit Card Numbers
Sometimes you may want to choose from among several long
distance carriers when you make a call. Rates may vary
depending upon the time and destination. To take advantage of
low rates, you can store the access codes or long-distance carriers
as One Touch numbers. You can store these long dialing
sequences by dividing them and setting them up on separate keys
in any combination. You can even include manual dialing using
the dial pad. The combined number will be dialed in the order you
entered it. as soon as you press
Start .
You can store “555” on One Touch key 03 and “7000” on One
Touch key 02 . If you press One Touch 03 , 02 , and Start , you can
dial “555-7000”. To temporarily change a number, you can
substitute part of the number with manual dialing using the dial
pad. For example, to change the number to “555-7001” you could
press One Touch
03 and press 7 , 0 , 0 , 1 using the dialing
pad.
If you must wait for another dial tone at any point in the dialing
sequence, store a pause at that point in the number by pressing
Redial/Pause . Each key press adds a 3.5 second delay.
WARNING
You can set up phone credit card numbers the same way.
However, when using combined dialing, do NOT send a cover
page because your credit card number will be on it!
Hold
1 Press Hold to put a call on Hold.
2 You can replace the handset without disconnecting the call.
3 Pick up the MFC handset to release the call from Hold.
Picking up an extension handset will not release the call from
Hold.
Pause
Press Redial/Pause to insert a 3.5 second pause between numbers. If
you are dialing overseas, you can press Redial/Pause as many times as
needed to increase the length of the pause.
See
Storing
One Touch Dial
Numbers
p. 8-1