Vanguard Managed Solutions Vanguard 7300 Series - Manual (Page 130)

4-20 Operating Your Vanguard 7300
Vanguard 7300 Port Configuration
Registering E.164
Numbers The phone number used in the Local Subscriber Address parameter is registered as
E.164 numbers. The Local Subscriber Address parameter is accessed from the Voice
Port Record of the FXS/FXO interface types. Figure 4-11 shows the FXS Virtual
Port Menu.
Figure 4-11. FXS Port and FXS Virtual Port Menu
Node: Address: Date:Time:
Menu: Configure Path:
Node
Port
--Signalling Mode
--PCM Mode
--Compression Rate
--VAD Control
--Smoothing Delay
--Echo Canceller
--Echo Return Loss
--Input Signal Level
--Output Signal Level
--FAX Support
--FAX Rate
--Call Control
--Call Mnemonic
--Autocall Timeout
--Autocall Retries
--Use Local Subscriber Address
--Group Subaddress (Hunt Group)
--No Answer Timeout
--Variable Digits Timeout
--Billing
--Local Subscriber Address
--Enhanced Debugging
--Rx Signalling State Change Filter
--T1/E1 Rx Idle (on-hook) State
--T1/E1 Tx Idle (on-hook) State
--T1/E1 Rx Active (off-hook) State
--T1/E1 Tx Active (off-hook) State
--T1/E1 Ringing State
--T1/E1 No Ringing State
--T1/E1 Busyout State
--Rx Disconnect Timer
--Line Error Recovery Time
--Rx Minimum Flash Hook Time
--Rx Maximum Flash Hook Time
--Re-configure DTMF/Pulse digits and Wink/Delay
Timer Parameters?
--Re-configure Call Progress Tone Parameters?
--Packet Delay Measurement Period
Port Number: 2000 to 3000 (Enter a virtual port number.)
Port Type: Voice
Access Type: Digital
Interface Type: FXS