Vanguard Managed Solutions Vanguard 7300 Series - Manual (Page 131)

Operating Your Vanguard 7300 4-21
Vanguard 7300 Port Configuration
Configuring the
Local Subscriber
Address The Local Subscriber Address parameter is accessed using the Voice Port Record
Options. To configure your Local Subscriber Address, select the Local Subscriber
Address parameter, and then enter the phone number you wish to register. That value
is registered with the gatekeeper as an E.164 address.
This table shows the range, default, and description of the Local Subscriber Address
parameter:
Changing the E.164
addresses If you change an E.164 address, you must force the registration with the gatekeeper.
Use the steps in this table to re-register a new E.164 address:
Figure 4-12. H.323 Node Parameter Menu
Range: 0 to 21 alphanumeric characters <space> blanks the field
Default: (blank)
Description: Specifies the Local Subscriber Address when the remote port is an
ISDN or Q.SIG port.
The Local Subscriber Address must be specified when Call
Control parameter is set to Switched and the Use Local Subscriber
Address parameter is Enabled. Under this configuration, this Local
Subscriber Address is used to search the Voice Switch Table.
Step Action
1 Reconfigure the IP address of the gatekeeper in the Vanguard gateway
using the H.323 Node Parameters. Figure 4-12 illustrates the H.323 Node
Parameter record.
2 Boot the H.323 Node Parameters to unregister the gateway.
3 Configure the gatekeeper’s IP address back to the original address.
4 Boot the H.323 Node Parameters to reregister with the gatekeeper.
--Gatekeeper IP Address
--Gatekeeper Port Number
--Gateway Time to Live Timer
--Prefix
Node: Address: Date:Time:
Menu: Configure Path:
H.323 Node Parameters