Vanguard Managed Solutions Vanguard 7300 Series - Manual (Page 49)

Vanguard 7300 Enclosures and Components 2-17
Vanguard 7300 Cards
Port Operating
Mode The “Port Operating Mode” parameter includes a range selection of 1000FD:
CPU Board Layout Figure 2-11 shows the layout of the Vanguard 7300 Series IBM750FX CPU card.
Figure 2-11. Vanguard 7300 Series CPU Card, IBM750FX
CPU Card
Installation
Information The IBM750FX CPU card must reside in the system slot of Vanguard 7300 Series
products. Slot 1 is the system slot on Vanguard 7300 Series routers. Only one CPU
card can be installed in a Vanguard 7300. Refer to “Removing and Replacing the
CPU Card and CPU Mezzanine Card (PMC)” section on page 5-11 for CPU card
installation instructions.
Port Operating Mode
Range: AUTO, 1000FD, 100FD, 100HD, 10FD, 10HD
Default: AUTO
Description: Specifies whether this LAN port runs in 1000Mbit Full-Duplex,
100Mbit Full-Duplex, 100Mbit Half-Duplex, 10Mbit Full-Duplex,
10Mbit Half-Duplex, or Auto-Negotiation Mode.
Note
Release 6.4 and greater software supports 1000FD on ports 101
and 103. ETH1 is port 101, ETH2 is port 103. Port 102 is the
COM port.
CPU Card Serial
No. Location