Vanguard Managed Solutions Vanguard 7300 Series - Manual (Page 88)

3-14 Vanguard 7300 Installation
Removing And Replacing Vanguard 7300 Front Covers
Vanguard 7310 and
7330 Version 2
Front Cover Panels Use the procedure in this table to remove and replace the 7310 and 7330 Version 2
front panel:
The Vanguard 7310
and 7330 Version 2
Front Cable Cover Vanguard 7310 and 7330 Version 2 front cover panel allows cables to be routed out
of the bottom, and right and left sides.
For convenience in routing cables, metal bridges are provided to secure cables with a
standard wire-tie. One metal bridge is provided on the front of the chassis (top right
side, above the power supplies). Additional bridges are located on the right and left
hand side on the rack mounting hardware.
Use the procedure above to remove and replace the front cover panel.
Figure 3-9. Vanguard 7310 and 7330 Version 2 Cover
Step Action
1 The front panel is held in place with a magnetic catch and can be easily
removed for maintenance or recabling. Hold the two handles on the sides
of the cover and pull straight out.
2 Place the cover panel on a flat level surface, painted side up.
3 To replace the cover, line up the cover with the front of the unit and push
until the magnets hold the cover in place.
4 Keep the cover on except for maintenance or recabling.