Vanguard Managed Solutions Vanguard 7300 Series - Manual (Page 90)

3-16 Vanguard 7300 Installation
Installing the Vanguard 7300 in a Rack
Procedure for
Rack-mounting Figure 3-10 shows the mounting hardware locations on the flanges of the Vanguard
7310 Version 1. For the locations on the Vanguard 7330 Version 1, refer to
Figure 3-11, For the locations on the Vanguard 7310 and 7330 Version 1, refer to
Figure 3-12. Use standard rack-mounting hardware (not supplied) to secure the
chassis in the rack.
Version 1 Rack-
mounting Use these steps for rack-mounting a 7310 and 7330 Version 1 Series router:
1) Remove the front covers. (See the “Removing And Replacing Vanguard 7300
Front Covers” section on page 3-8.)
2) Two people are required to position the chassis and slide it into the front of the
rack.
3) Attach the front of the chassis to the rack:
• Secure the Vanguard 7310 Version 1 with mounting hardware at four locations,
two on each side of the front panel (Figure 3-10)
• Secure the Vanguard 7330 Version 1 at eight locations, four on each side of the
front panel (Figure 3-11)
Figure 3-10. Rack Mount Hardware Locations - Vanguard 7310
POR
T 1
POR
T 2 ACT 100bT LINK
POR
T 1
POR
T 2 ACT 100bT LINK EXT
PWR
ABT RST BFL CPCI USB 1 COM 1 10/100 BASE T USB 0
CPU PCI
PCI MEZZANINE CARD
POR
T 1
POR
T 2 ACT 100bT LINK
P M C 2
D E B U G HO T SW
AP RESET
P M C 1 11 7 3
8 W A N 4 0
Univer
sal
Serial I/O EXT
PWR