Vita-Mix XTG012 - Manual (Page 3)

13. Always operate with the lid in place.
14. WARNING: When processing hot liquids:
• The two-part latching lid must be securely in place. This allows
steam to escape naturally and will prevent the lid from coming off
when the machine is turned on.
• Use caution with hot liquids. Spraying from under the lid plug can
occur or escaping steam may cause scalding.
• Do not process hot liquids with the non-latching lid.
15. Display window area will scratch when contacted with a scouring pad or
sharp object. Use a soft cloth to wipe the control panel area clean.
16. The Blending Station ® MP cannot be cleaned with a water jet.
17. Installation for a 120 VAC unit requires you to have at least one 20 amp
outlet per machine, available within six feet of the Blending Station MP.
220 VAC and 100 VAC units require a dedicated line. Consult an
electrician for proper electrical needs.
Enjoy the safety of this grounded appliance. The Blending Station MP
U.S. power cord comes equipped with a three-prong (grounding) plug which
mates with a standard three-prong wall outlet (Figure A). This cord will vary
for countries outside the United States.
Adapters (Figure B) are available for two-prong outlets. Do not cut or
remove the third (ground) prong from the plug or power cord.
Consult your electrician if you are not sure if the wall outlet is grounded
through the building wiring. With a properly grounded two-prong wall outlet,
ground the Blending Station MP by attaching the tab on the adapter to the
wall outlet cover by means of the screw in the center of the cover (Figure B).
SAVE THESE INSTRUCTIONS
Figure A Figure B
THREE PRONG
ADAPTERS ARE
NOT TO BE USED
IN CANADA.
3