Western Telematic MPC-20VS16-3 - Manual (Page 204)

Apx-13
Appendices
E.5. Universal Mounting Bracket (MPC-20V Series Only)
The Universal Mounting Brackets are used to mount vertical format MPC units to
equipment rack posts or mounting pads. The Universal Mounting Brackets are often
used in cases where the power supply cable enters the rack from above, and allow the
unit to be easily mounted upside down.
To mount the unit using the Universal Mounting Brackets, proceed as follows:
1. Attach the Brackets to the Unit:
a) Locate the two pairs of mounting holes at the top and bottom of the MPC back
panel. There should be a pair of holes at the top of the back panel and a pair
of holes at the bottom.
b) Refer to Figure E-8 on the following page, and then use the retainer screws to
attach one Universal Mounting Bracket to the top of the back panel, and one
Universal Mounting Bracket to the bottom of the back panel. Prior to attaching
the mounting brackets, make certain that the beveled edge of the screw holes
faces outward, so the head of the screw will nest within the bevel.
2. Attach the MPC unit to the Rack:
a) Use a retaining screw to secure the top mounting bracket to the equipment
rack post or mounting pad as shown in Figure E-8.
b) Make certain that the MPC hangs level and straight, and then use a retaining
screw to attach the bottom mounting bracket to the lower portion of the rack
post or mounting pad, securing the unit to the rack.