Western Telematic MPC-20VS16-3 - Manual (Page 90)

5-59
Basic Configuration
5.9.7. SNMP Trap Parameters
These menus are used to select parameters that will be used when SNMP traps are
sent. For more information on SNMP Traps, please refer to Section 12. To define or
change SNMP Trap parameters, proceed as follows:
• Text Interface: Type /N and press [Enter] to display the Network Parameters
Menu (Figure 5.17.) At the Network Parameters Menu, type 26 and press [Enter] to
display the SNMP Trap Parameters Menu.
• Web Browser Interface: Place the cursor over the "Network Configuration" link
on the left hand side of the screen. When the fly-out menu appears, click on the
"SNMP Traps" link to display the SNMP Trap Parameters Menu.
Both the Text Interface and Web Browser Interface allow the following parameters to be
defined:
• SNMP Manager 1: The IP Address for the first SNMP Manager. For more
information, please refer to Section 12. (Default = Undefined.)
Note: In order to enable the SNMP Trap feature, you must define at least one
SNMP Manager.
• SNMP Manager 2: (Default = Undefined.)
• Trap Community: (Default = Public.)