Western Telematic MPC-20VS16-3 - Manual (Page 34)

5-3
Basic Configuration
5.1.2. The Web Browser Interface
The Web Browser Interface consists of a series of web forms, which can be used to
select configuration parameters and perform reboot operations, by clicking on radio
buttons and/or entering text into designated fields.
Note: In order to use the Web Browser Interface, Web Access must first be
enabled via the Text Interface Network Parameters Menu (/N), the MPC must
be connected to a TCP/IP network, and your PC must be equipped with a
JavaScript enabled web browser.
1. Start your JavaScript enabled Web Browser, key the MPC’s IP address (default =
192.168.168.168) into the web browser’s address bar, and press [Enter].
2. Username / Password Prompt: A message box will prompt you to enter your
username and password. The default username is " super" (all lower case, no
quotes), and the default password is also " super".
3. If a valid username and password are entered, the MPC Home Screen will appear
as shown in Figure 5.2.
Figure 5.2: The Home Screen (Web Browser Interface)